Mains Supply; Measurement - Circutor MH-10 Guia Del Usuario

Mains supply

MH-10 is manufactured in different versions, to be compliant with the mains
supply specifications in the destination country. Please, check the value indi-
cated in the Control Panel in order to be sure that it is appropriate for the local
A.C. supply.

Measurement

1. Before turning the equipment on, connect the test leads to the item to be
measured and to the front panel terminals.
2. Using the CURRENT SELECTOR0, choose the range and the current to
be used.
3. Choose the power supply to use. If you are going to use the battery, ad-
vance to the following point. If you are going to use the mains supply, plug
the power cord into the connector".
4. Switch the equipment on using the ON/OFF#.
ELEMENT TO BE MEASURED
8
The alligator clamps in
the drawings are only
for illustration. The
supplied clamps could
be different than what's
shown in the drawing.