FGE Farelek 112501 Manual De Instrucciones página 59

• If problems cannot be solved via the procedures given below, stop the air
conditioner and contact our After Sales Service.
Problem
The air conditioner does not work.
The remote control is not availa-
ble or there is no display.
The unit does not work when I press the
ON/OFF key.
The cooling and heating are not very efficient.
Air does not come out immediately when I
activate the «HEATING» mode.
112501-505-506-507-H.indd 59
• Is there a power failure?
• Is the plug unplugged?
• Is the fuse or the supply switch cut out?
• Is the voltage higher than 253V or lower than
207V?
• Is the timing programmed correctly?
• In cases of abnormal use or too frequent changes
in operating mode, the remote control may stop
functioning. Disconnect and then reconnect the unit.
The problem should be solved.
• If the remote control displays unfocussed symbols
or all the symbols, replace the batteries.
• It concerns a protection system for the
compressor depending on instructions from the
microprocessor.
Please wait for 3 minutes.
• Is the temperature defined correctly?
• Are the filters dirty?
• Are the inputs and outputs of the external unit
obstructed?
• Is the sleep function activated for day?
• Is the internal fan set at a very low speed?
• Are the doors and windows closed?
• This is quite normal, air will only be diffused
when it is sufficiently hot. Please wait.
© FAR GROUP EUROPE
Explanation
10/02/06 8:12:00
EN