Block Diagram Of The Device - Aprimatic A80M-2 Professional Instrucciones Para La Instalación

Device with an Aprimatic microprocessor designed to operate 1 motor with a
maximum absorbed power of 400 W.

1.1 BLOCK DIAGRAM OF THE DEVICE

L1 Closing limit switch LED
Always ON - it goes OFF following the closing limit switch signal
L2 Opening limit switch LED
Always ON - it goes OFF following the opening limit switch signal
L3 Photocell/safety LED
Always ON - it goes OFF following the safety signal
L4 Stop LED
Always ON - it goes OFF following the stop command
L5 Start LED
Always OFF - it comes ON following the start command
L6 Diagnostic LED (see diagnostic procedure)
L7 Pilot light LED
L8 Motor LED
L9 Direction LED
L10 Brake LED
J1 Signal terminal board (inputs)
J2 Power supply terminal board (outputs)
J3 Decoding board/plug-in radio receiver connector
J4-J5 Optional board connector
F1 Fuses from 2A output 24VDC
F2 Fuses from 5A power supply 230 V
K1 Brake relay
K2 Motor relay
K3 Direction relay
T1 Transformer
TR Brake time adjusting trimmer
SW1 Time setting dip-switch
SW2 Functioning mode dip-switch
U1 Microprocessor
INPUTS
Gear motor terminal board
OUTPUTS
APR01001.EPS
A80M-2 terminal board
Closing
Opening
Blue (common lead)
230 V ± 10% - 50 Hz
Connect to a 6A differential
switch with a sensitivity of 30 mA