Samsung WF42H5000A Serie Manual Del Usuario página 17

12. Connect the other ends of the water hoses to the corresponding
inlets on the rear of the machine as specified. Make sure the hot
water hose is connected to the hot inlet, and the cold water hose
to the cold inlet.
13. Repeat step 2 above on the other fittings. Make sure both water
hoses are connected properly. See the '4E' information code for
troubleshooting.
14. Open both faucets, and check if there is a leak.
WARNING
Wall standpipe drain system
1. The drain hose must be placed into a wall standpipe drain system.
To keep the end of the drain hose bent, use the supplied hose
guide (A). Secure the guide to the wall using a hook to ensure
stable drainage.
2. Open the water tap and check if there are any leaks around the
connection areas. If there are water leaks, repeat thesteps above.
BETTER_WF42H5000-03397A-14_EN.indd 17
If you do not want to use the hot water hose, insert the inlet cap
into the hot water inlet. In this case, you must select Tap Cold
for the water temperature. All other water indicators turn off.
To prevent water hoses from being bent or kinked, make sure
there is at least a 6 inch (150 mm) space between the washer
and the rear wall.
English _17
A
2018/8/14 11:37:47