End Programming - Erreka AZIMUT AZS50E Manual Del Usuario

8. Maintenance alarm (default: 0 – function deactivated)
If this function is activated, the device emits BEEPs when the motor reaches 2000 operational cycles.
This alarm may be useful for scheduling maintenance operations.
To interrupt the alarm , simply press and hold the START button for 5 seconds, or power off the device for several seconds.
-
Press the key,
the display shows 8
9. Step-by-step operation/Collective opening (by default: 0 – Step-by-step operation)
This menu can be used to select automation operation mode during opening and closing.
Step-by-step operation: Every time the button and/or remote control is pressed, the panel sequentially runs the commands: Open - Stop -
Close – Stop - Open - Stop-....
Collective Opening Operation: During Opening stage the operation will not be interrupted if the button and/or remote control is pressed,
whilst during Closing stage the door opens again completely.
Press the - button and the
9
screen will display

10. End programming

To exit the programming and store the settings of the different parameters, it is necessary to follow this procedure:
Press the + key until the
display shows I
Press the key: 0 flashes
to indicate that the function
is deactivated
0
Press the button:
flashes to indicate
step-by-step operation
Press and hold the key
for 5 seconds: I flashes
Press the + key to activate
the function: the display
shows I
Press the + button to change
to Collective Opening
Operation: the screen
1
displays
Release the key: the
segments of the display
illuminate one at a time
until showing 0
34
Press the key to save
the settings: the display
shows 8
Press the key to save
the settings: the display
shows 9