Additional Safety Instructions For Rotary Hammer - Hilti TE 70-AVR Manual De Instrucciones

a "live" wire may make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
Safety instructions when using long drill bits
▶ Never operate at higher speed than the maximum speed rating of the
drill bit. At higher speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in personal injury.
▶ Always start drilling at low speed and with the bit tip in contact with
the workpiece. At higher speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece, resulting in personal injury.
▶ Apply pressure only in direct line with the bit and do not apply
excessive pressure. Bits can bend causing breakage or loss of control,
resulting in personal injury.
Safety instructions for using mixing paddles or stirrers
▶ Switch the power tool on or off only when the mixing paddle is
immersed in the material for mixing. Failure to do so can cause a loss
of control with resultant risk of injury.

2.3 Additional safety instructions for rotary hammer

Personal safety
▶ Use the product only when it is in technically faultless condition.
▶ Never tamper with or modify the power tool in any way.
▶ Use the auxiliary grips supplied with the tool. Loss of control can cause
personal injury.
▶ Apply appropriate safety measures at the opposite side of the workpiece
in work that involves breaking through. Parts breaking away could fall out
and / or fall down causing injury to other persons.
▶ Always hold the power tool with both hands on the grips provided. Keep
the grips clean and dry.
▶ Hold the power tool by the insulated gripping surfaces when performing
work in which the accessory tool might come into contact with concealed
wiring. If the accessory tool comes into contact with a live wire, metal
parts of the power tool can also become live, resulting in an electric
shock.
▶ Avoid touching rotating parts – risk of injury!
▶ Wear suitable protective glasses, a hard hat, ear defenders, protective
gloves and light respiratory protection while using the power tool.
▶ Wear protective gloves also when changing the accessory tool. Touching
the accessory tool presents a risk of injury (cuts or burns).
▶ Wear eye protection. Flying fragments present a risk of injury to the body
and eyes.
▶ Before starting work, check the hazard class of the dust that will be pro-
duced when working. Use an industrial vacuum cleaner with an officially
approved protection class in compliance with the locally applicable dust
protection regulations. Dust from materials such as lead-based paint,
6 English
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
2063039
*2063039*