Hilti TE 70-AVR Manual De Instrucciones página 18

Trouble or fault
Combihammer does
not achieve full
power.
Drill bit does not
rotate.
Drill bit is not re-
leased.
The service indicator
blinks red.
The service indicator
lights red.
9 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
14 English
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
Possible cause
The voltage provided by
the electric supply is too
low.
TE 70-ATC-AVR
TE 80-ATC-AVR
The half-power button is
engaged.
The function selector
switch is not engaged or
is in the "Chiseling" po-
sition or the "Chisel
positioning" position
The chuck is not pulled
back fully.
The side handle is not
fitted correctly.
A fault has occurred in
the tool.
The carbon brushes are
worn.
Action to be taken
▶ Connect the power
tool to a different
power source.
▶ Press the "half-power"
button.
▶ With the motor at
a standstill, set the
function selector
switch to the "Hammer
drilling"
.
▶ Pull the chuck back
as far as it will go and
remove the accessory
tool.
▶ Disengage the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
▶ Have the product
repaired by Hilti
Service.
▶ Have checked, and if
necessary replaced,
by a trained electrical
specialist.
2063039
*2063039*
position.