Troubleshooting - Emerson Warm Tiles ES Manual Del Usuario

12. Troubleshooting 1/5

1
1 2 3 4
5
PAGE 67
All Rights Reserved. Used under license by EasyHeat Inc.
Error messages
If a fault or error occurs, the thermostat will display one of the following error
messages:
1. E0: Internal failure. The thermostat is defective. Contact your installer.
The thermostat must be replaced.
2. E1: Internal sensor defective or short-circuited. Contact your installer.
The thermostat must be replaced.
3. E2: External wired floor sensor disconnected, defective, or short-circuited.
Contact your installer for reconnection or replacement.
4. E5: Internal overheating. Contact your installer in order to have the installation
inspected.
Note! If any of the above mentioned errors occur, the heating is shut off.
5. Three circles containing dots are shown on the screen; the thermostat cannot be
operated.
The thermostat is in "Child Lock" mode. See the section titled "Child Lock" in
this manual for instructions on how to unlock it.
<
Contents
>