Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Optional
M4 Tapping Screws
(Not included: screw
Mounting Bracket
length depends on vehicle)
Vehicle Roof
M4 x 13 Machined Screws (4)
(Included)
Install trim ring before attaching the overhead
monitor to the metal installation bracket.
The trim ring is used to make the monitor sit flush against the
ceiling contour. Ask ALPINE dealer for detail.
Screw the shroud to the monitor body using the provided screws.
4
Install the overhead monitor to the ceiling.
Connect the cables and then install 4 screws to the metal
installation bracket.
Rear screw holes
Front screw holes (underneath LCD screen)
(Left rear screw not illustrated)
4
-EN
5
Install the rear interchangeable color cover.
Align the openings on the cover with the rear button panel.
Press down firmly to snap the cover into place.
Ensure that all notches have gone into their grooves
properly.
Roof Support
Headliner
Removing Interchangeable Color Cover
1
Remove the rear interchangeable color cover.
Reach across the monitor body and grasp the rear panel.
Gently lift the panel until it snaps off from the body.
2
Remove both side panels of the interchangeable
color covers.
Grasp side cover as illustrated.
Raise the corner touching the rear control panel a few
millimeters and gently slide the cover out.
Do not immediately lift the cover before sliding it. The
notches will be damaged.
A small flat screwdriver or similar tool can be used to raise the
corner of the panel.
Publicidad
Tabla de contenido
