Vac Assembly; Replacement Filter Assembly; Important; To Store Your Accessories - RIDGID WD0625 El Manual Del Propietario

Replacement Filter Assembly

1. Carefully slide the filter over the filter
cage. Line up hole in filter plate with
threaded stud and slide it down until the
filter stops against the plate.
2. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from filter as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage.

To Store Your Accessories

1. Slide extension handles and accesso-
ries on to posts of the caster feet for
storage.
2. To remove handles and accessories,
lightly rotate and pull upward.

Vac Assembly

1. Line up vacuum port above drum label.
2. Place lid on top of drum with the han-
dles snug against the drum channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid from
coming off.
Power Head
Vacuum Port
Drum
Channel

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Push
Down
Pull
Out
Flexible
Locking
Tab
5
Filter Nut
Filter Plate
Filter
Filter
Cage
Release Button