Drum/Caster Foot Assembly - RIDGID WD1450 El Manual Del Propietario

SP6542 14 Gallon

Drum/Caster Foot Assembly

If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Insert the front and rear caster feet into
the bottom of drum as shown. Light taps
with a mallet or hammer may be needed
to fully seat both caster feet.
2. Install (4) #10 x 1-3/4" screws into
matching holes on both front and rear
caster feet, securing them to the bottom
of the drum. Tighten screws until just
snug. Do not over tighten as this may
tend to deform the caster feet.
3. Insert the caster stem into each of the
caster feet, as shown.
4. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
9/7/04 1:31 PM Page 7
Drum
Front
Caster
Foot
Drain
#10 x 1-3/4"
Screw (4)
Rear
Caster
Foot
Caster Stem
Caster Ball
Socket
7
Rear
Caster
Foot
Drain
Front
Caster
Foot