VDS EGO Manual Técnico De Instalación página 19

INSTALLATION OF FASTENING PLATES
Fix the back plate to the pillar.(FIG. 1)
Anchor the rear part of the piston to the
plate and fasten it firmly.( FIG. 2)
(FIG. 2)
Warning! When establishing the height off the ground at which to fasten the plate
to the post (fig. 1), keep in mind that the plate for anchoring the piston to the gate
must be fastened at the same level (fig. 3)
Installing the anchor plate on the piston to the gate
1. Fit the anchor plate onto the piston (fig. 4)
2. Close the gate
3. Move the piston with the plate already fitted towards the gate
4. Move the fitting to limit stop, then move it back by approximately 1cm and mark
the position of the plate.
5. realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A and B units
(table 1)
(FIG. 1)
(FIG. 3)
(FIG. 4)