Louisville AA2210 Instrucciones De Instalación página 5

STEP 1: PRELIMINARY INSTALLATION INSTRUCTIONS
A. Attach temporary supports "A" and "B" with 2 ½" deck screws as shown in Figure 4.
Support "A" should be located at the end where the door hinge of the ladder will go. The
edge of support "A" should extend into the rough opening 3/8" as shown in Figure 5. Make
sure both screws penetrate header above ceiling.
B. Measuring from the inside edge of support "A", locate and secure the inside edge of support
"B" 53" from inside edge of support "A" (Figure 5). Make sure both screws penetrate
header above ceiling.
C. Thread pull cord through pre–drilled hole in door and tie a knot in end of cord. Length can
be adjusted after ladder is completely installed. Be sure the knot is large enough to not slip
through the hole.
For aluminum models, remove aluminum feet on bottom section. These will be
reinstalled in Step 3.
D. Position one person up in the attic, and position the other person in the room below. When
using stepladder make sure ladder is fully open, all feet firmly supported and user's weight
and materials he is carrying does not exceed the load rating of the ladder.
Deck screw (2) per board
FIGURE 4: View from below
FIGURE 5: View from above
4