Craftsman 358.350590 Manual De Instrucciones página 21

TROUBLESHOOTING TABLE - Continued
TROUBLE CAUSE REMEDY
Oil inadequate 1. Oil tank empty. 1. Fill oil tank.
for bar and 2. Oil pump or oil filter 2. Contact Sears Service.
chain clogged.
lubrication. 3. Guide bar oil hole 3. Remove bar and clean.
blocked.
Chain moves at 1. Idle speed requires I. See "CarburetorAdjustment" in the
idle speed, adjustment. Service and Adjustments Section.
2. Clutch requires repair. 2. Contact Sears Service.
Chain does not 1. Chain tension too I. See "Check Chain Tension" in the
move when en- tight. Maintenance Section.
gine is acceler- 2. Carburetor requires 2. See "CarburetorAdjustment" in the
ated. adjustment. Service and Adjustments Section.
3. Guide bar rails 3. Repair or replace.
pinched.
4. Clutch slipping. 4. Contact Sears Service.
5. Chain brake engaged. 5. Disengage chain brake.
1. Chain tension incorrect. Chain clatters
or cuts roughly.
2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly
sharpened, or depth
gauges too Mgh.
5. Sprocket worn.
6. Chain installed
backwards.
1. See "Check Chain Tension" in the
Maintenance Section.
2. Contact Sears Service.
3. Resharpen or replace chain.
4. See "Chain Sharpening" in the
Service and Adjustments Section.
5. Contact Sears Service.
6. Install chain in right direction.
Chain stops 1. Chain cutter tops not 1. See "Chain Sharpening" in the
within the cut. flied flat. Service and Adjustments Section.
2. Guide bar burred or 2. Repair or replace guide bar.
bent; rails uneven.
3. Clutch slipping. 3. Contact Sears Service.
Chain cuts at 1. Cutters damaged on 1. See "Chain Sharpening" in the
an angle, one side. Service and Adjustments Section.
2. Chain dull on one side. 2. See "Chain Sharpening" in the
Service and Adjustments Section.
3. Guide bar bent or worn. 3. Replace guide bar.
If situations occur which are not covered in this manual, use care and good
judgement. If you need assistance, contact Sears Service or the CUSTOMER
ASSISTANCE HELPLINE at 1-888-235-5878.
21