Operation And Controls; Continuous Shaking; Timer Controlled Shaking - Heidolph Multi Reax Manual De Instrucciones

IEI
Before connecting power cord with mains outlet, make sure that:
your item is wired for your local voltage and frequency (data plate on item).
-
master switch is set to "0" and all controls are in "min." position (turn CCW
-
completely); this way you avoid spilling fluids by too intense shaking action.
Carefully close your vessels and select appropriate shaking intensity (if vessels
remain open) to avoid splashes and spillage.
We recommend to start with low shaking speed and gradually increase frequency to
avoid accidential shaking at high speed.
When handling hazardous fluids, make reference to applicable safety information.
The control panel features the following controls (from right to left):
A 2-pole master switch (toggle-type, lighted green on the right side of the unit)
B setting knob, shaking frequency
C Set Time key : time up
D Set Time key : time down
E Select key: display selector: shaking frequency (Act Speed) / time (Act Time)
F LED Time: time appears in display
G LED Speed: rotational speed (shaking frequency) appears in display
H Start / Stop key: to START / STOP shaking action
I LED Start /Stop: lighting, while item is running
J 4-digit display
I
J
H
G
A. Continuous shaking

Turn item ON with master switch (A)

Set time with  and  keys to 000 (depress  and  together).

Start continuous operation by hitting the Start / Stop key. Start and Speed LEDs turn on,
shaking frequency is displayed (4-digit display).

Set shaking frequency with knob (B)

Hitting Start / Stop key will stop shaking.
B.

Timer controlled shaking


Set time between 0 and 999 minutes with Set Time  or Set Time  keys.
Short hits on the keys change time setting slowly, whereas depressing keys is going to

OPERATION AND CONTROLS

F D
B
C
E
20
A