Install The Kpr2000; Choose An Operation Mode - LiftMaster KPR2000 Manual Del Usuario

Teclado/lector de proximidad resistente al agua
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION
1

Install the KPR2000.

Fits a standard single outlet box, or a 2.4" square pedestal mount.
2

Choose an Operation Mode.

STAND ALONE OPERATION
The KPR2000 functions as a complete access control system. The user
database is stored in non-volatile memory, reads the PINs and card
codes, performs the authentication, and grants and monitors access to
the property or device. In Stand Alone Operation there are three different
Access Configurations listed below:
• Card or PIN (Default): The User must present a valid Wiegand Card to
the KPR2000 or enter their PIN code followed by the # key, in order to
be granted access.
• Card Only: The User must present a valid Wiegand Card to the
KPR2000 in order to be granted access. The facility code and the ID
number are both read and validated as one block of Wiegand data.
• Card + PIN: The User must first present a valid Wiegand Card to the
KPR2000 and then enter their PIN code followed by the # key, in order
to be granted access.
Trim Plate
(optional)
4"
PASS-THROUGH OPERATION
The KPR2000 passes all keypad and card reader Wiegand data to an
external controller. The KPR2000 should be in the "Card or PIN" access
configuration for pass-through operation. In this mode the LED will stay
red, and the KPR2000 will beep 3 times when credentials are presented
that are authenticated to the external controller. To change this mode and
allow the KPR2000 to flash the green LED, and beep 1 time, the KPR2000
will have to learn the same credentials as the external controller.
IMPORTANT NOTE: Both modes of operation support Auto User ID
generation (simplest method) and manual entry of user ID.
KEYPAD OPERATION
The KPR2000 keypad may output an 8 bit ASCII code every keystroke, or
output a 26 bit Wiegand card packet with a facility code and a 4-5 digit
card number when the # key is pressed. See configuration options on
page 5.
3
4"
3"
2.4"
.29"
Ø 1.81"
Face Plate

Publicidad

Tabla de contenido
loading

Tabla de contenido