Troubleshooting - Black+Decker EMax34i Traducción De Las Instrucciones Originales

ENGLISH
Place the grass collection box on the ground and pull in
u
and hold the grass compaction lever release button (30).
Lift the grass compaction lever (29) into the vertical
u
position and release the grass compaction lever release
button (30).
Empty the contents from the rear of the box.
u
Emptying the grass collection box (EMax34s only)
When the grass collection box is full you should empty the
grass in the collection box.
Release the on/off switch (2).
u
Remove the grass collection box (9).
u
Empty the contents from the box.
u
Carrying the mower
Warning! Ensure the blade has completely stopped and
disconnect the appliance from the mains.
The mower can be carried using the convenient carry
u
handles (11).
Hints for optimum use
If the grass is longer than approximately 10 cm, make two
u
cuts to obtain a better finish. First mow at maximum height
of cut, then use a low or medium height of cut.
In order to achieve optimum results, only mow dry grass.
u

Troubleshooting

If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Warning! Before proceeding, remove the plug from the
socket.
Problem Possible Cause
Machine fails to Power turned off
operate
Fuse faulty/blown
Grass too long
Thermal cut out
activated
Machine functions Thermal cut out
intermittently
activated
4
(Original instructions)
Possible solution
Turn power on
Replace fuse
Increase the height of
cut and move machine
to shorter grass to start
Allow motor to cool and
increase height of cut
Allow motor to cool and
increase height of cut
Problem Possible Cause
Machine leaves
Height of cut too low
ragged finish or
Cutting blade blunt
motor labours
Underside of machine
clogged
Blade fitted upside
down
Technical data
EMax34s
EMax34i
Type 04
Voltage
V
AC
Power Input W
No-Load Speed -1
min
Height adjustment mm
Blade length mm
Weight kg
Hand/arm weighted vibration value according to EN60335:
= 3.2 m/s , uncertainty (K) = 1.5 m/s
2
Possible solution
Increase height of cut
Replace the blade
Check underneath the
machine and clear out
as necessary (always
wear heavy duty
gloves)
Refit blade correctly
EMax42i
EMax38i
EMax42ri
Type 05
Type 05
230-240 230-240 230-240
1400 1600 1800
3500 3500 3500
20-70 20-70 20-70
340 380 420
12.1 13.3 13.9
.
2