Coltene CanalPro CL Instrucciones Para El Uso página 37

NOTICE
- If the speed or torque set value has reached the upper limit or lower limit when the gear ratio has been
changed, the alarm sounds.
- The indication of "- -" for torque setting is the upper limit value of torque. If you attempt to set torque
which exceeds this value, the alarm sounds.
- The speed can be set at any time if it is normally indicated.
„ PROGRAM Key
A program can be selected.
The present program number is displayed. There are 5 programs available, numbered from 1 to 5.
Up to five programs can be set, and program settings can be memorized by pressing this key for one sec-
ond or longer. The following parameters can be set: Speed, torque, gear ratio and auto reverse setting.
„ UP/DOWN Key
Use this key when adjusting the set value for each parameter. Alarm sounds if the set value exceeds the
upper limit or lower limit. Unit to be set is min
<LCD panel>
„ Auto Reverse
The current auto reverse mode mark is displayed.
AUTO REVERSE: If the load is removed after auto reverse rotation, it returns to the
normal rotation again.
AUTO STOP: If the load is removed after auto reverse rotation, it stops.
AUTO REVERSE OFF: Auto reverse rotation is not activated. (There will be no symbol
displayed)
„ Battery Symbol
The symbol indicating the battery status is displayed. The symbol will be animated when the batteries
are being charged or in the refresh mode.
: Full charge or nearly full charge
: About 30-80% remains
: Less than about 30% remains
: Batteries are drained or in a remarkably low voltage. Charge the batteries.
-1 for speed and N·cm for torque.
37