Control Panel & Display; Cool Mode; Fan Mode - Sharp CV10CTXB Manual De Instalación Y Funcionamiento

CONTROL PANEL DISPLAY & OPERATING INSTRUCTIONS
CONTROL PANEL & DISPLAY
OPERATING INSTRUCTIONS
When pressing key, buzzer makes a sound, indicator lamp shows relevant
state for 2 seconds.
1. ON/OFF Button
Press the button once to manually turn the unit on. Press once more to turn the unit off.
2. "+" , "-" Button
In COOL mode, press "-" once, the set temperature will decrease 1º C( F) , press "+" once,
the set temperature will increase 1ºC ( F). The set temperature range from 16º C to 30º C (61º
F to 86º F).
3. MODE Button
Press MODE Button repeatedly to cycle between the modes: Cooling, Dry (Dehumidifica-
tion), and Fan only mode. Each press of the MODE button will light up a different lamp on the
control panel. The exhaust hose and window kit must be installed when the unit is in Cool or
Dehumidification mode. When using the unit as a fan, it is unnecessary to keep the exhaust
hose and window kit connected to the unit.
4. Fan Speed Button
When the unit is running in Cool or Fan mode, press the Fan Speed Button to select the fan
speed in High, Middle, Low, Auto.
5. Water Full
When COOL or DRY (Dehumidification) is running, condensation will drain to the water tank.
When water tank is full. buzzer will sound 8 times, and LED screen will show error code 'H8'.
In this case, drain out water tank.
6. Louver Direction
This unit has 4-Way directional louvers. Use the
louver guides to direct air where cooling or fanning is
needed most. Hold the louver and adjust the air flow
direction, as show in the right diagram.
Temperature selection button LED window
FAN Speed lamp ON/OFF button
Fan speed button
Hold this hand grip to adjust the
direction of Horizontal Louvers
EN-18
COOL mode lamp Receiver window
DRY
mode lamp
MODE button
FAN mode lamp
Hold this hand grip to adjust the
direction of Vertical Louvers