Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
- the front measuring-tool edge (e.g. when measuring
onward from a table edge)
To change the reference level, press button 6
time after switching on the measuring tool, the rear end of the measuring tool is preset as the reference level.
Length Measurement
Press button 1
Press button 1
the d isplay.
Calculation function (+/-)
After switching on, when you want to measure the total distance, after you measure the first distance, press"+", then
again press button 1
to measure the distance you want to add, it can calculate automatically, the result displayed.
After switching on, when you want to measure the short distance after you measure the first distance, press "-", then
again press button 1
to measure the distance you want to sub, it can calculate automatically they result displayed.
Area Measurement
After switching on, press button 2
Press button 1
to measure the length and the width, one after another, in the same manner as a length
measurement. The laser beam remains switched on between both measurements.
Volume
After switching on, press button 2
Press button 1
to measure the length width and the height, one after another, in the same manner as for a length
measurement. The laser beam remains switched on between all three measurements.
Indirect Length Measurement
The indirect length measurement is used to measure distances that cannot be measured directly because an obstacle
would obstruct the laser beam or no target surface is available as a reflector. Correct results are achieved only when the
laser beam and the sought distance from an exact right angle (Pythagorean Theorem).
until the requested reference level is indicated on the display. Each
to activate the laser, and aim at the object which is to be measured.
again to take measurement, the measured value is indicated at the bottom in
until the indicator for area measurement
After taking the second measurement, the area/surface is automatically calculated and
displayed. The last individual measured value is indicated at the second line in the
display, while the final result is shown at the bottom.
until indicator for volume measurement
After taking the third measurement, the volume is automatically calculated and
displayed. The last individual measured value is indicated at the middle line in the
display, while the final result is shown at the bottom.
appears on the display.
Measurement
appears on the display.
Publicidad
Tabla de contenido
