Mounting And Placement - Amate Audio G7 Manual De Usuario

G7

Use the switch to select the position that corresponds to the
required power.
Power Impedance
(100 V line)
5 W 2 kΩ
10 W 1 kΩ
20 W 500Ω
40 W 250Ω
If you are working in 100 V line mode and you choose (i.e) 40 W / 250 Ω
selector, then that (40 W) will be the maximum power that will accept the
cabinet.
If you are using an amplifier that gives 1200 W, then the maximum
number of cabinets that you can use will be 30 (1200 W / 40 W).
If you are using an amplifier that gives 2000 W, then the maximum
number of cabinets that you can use will be 50 (2000 W / 40 W).

3. MOUNTING AND PLACEMENT

For a proper installation of the acoustic cabinets, it is strongly
recommended to read carefully the following advices.
3.1. Placement
The cabinets should
be located in a high
position, slightly
inclined to the
audience. If the
loudspeakers are
located too low, the
listeners at the end of
the room will not hear
a good sound quality.
Amate Audio
July2020 G7
3.2. Flying
Only experienced people should fly speaker cabinets. Extreme care
should be taken to assure the load bearing capabilities of the
structures where the cabinets will be placed. Hanging hardware (as
chains, eyebolts, lock pins...) should be regularly inspected and
replaced if in doubt.
3.2.1. Flying with "U" bracket (included)
 Hold the bracket against the mounting surface, so you can mark the
locations of the mounting holes

Drill corresponding pilot holes on the wall and attach the bracket
with screws
Amate Audio
July2020