Powermate PM2015 Manual De Uso página 12

Assembly
(Continued)
• Save all instructions
TO ASSEMBLE THE WHEELS (See Figure 8)
IMPORTANT: Before assembling the wheels, consider your
lawn and decide which available cutting height is best for
your lawn. For best results, never cut off more than one-
third of the total length of the grass.
NOTE: Use 3/4 and 9/16 in. wrenches, sockets or adjust-
able wrenches to complete the following steps.
Each corner of the mower deck has a group of 3 vertical
holes representing the 3 possible cutting height settings.
The cutting height is fixed and adjusted with the choice of
hole the wheels are assembled. Make sure to assemble
the wheels in the same choice of hole for each corner of
the deck.
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
Item numbers in assembly instructions and figure correspond
to parts list on page 9.
1. Secure each wheel to the deck by inserting the
axle bolt (item 1) into and through the wheel (item 16),
washer (item 9), and hole in the deck. Secure with
flange nut (item 11).
a. To adjust the cutting height, disassemble each wheel
and re-assemble to your new choice of hole location /
cutting height.
NOTE: Make sure all four (4) wheels are assembled in the
same wheel height position.
ENG - 12
Hole for 2.25"
cutting height
Hole for 2.88"
cutting height
Hole for 3.5"
cutting height
Copyright © 2016 MAT Engine Technologies, LLC
Figure 8