Engine Care - Powermate PM2015 Manual De Uso

Routine Maintenance
• Save all instructions
5. Position the blade onto the blade adapter in the correct orientation. On each end of the blade, a blade "lift" portion
lies on the opposite side of the blade from the sharpened edge. When positioning the blade onto the blade adapter,
make sure the blade "lift" portion is facing towards the mower deck. See Figure 11.
6. Assemble the retaining bolt through the flat washer, (2) disc spring washers, blade, and blade adapter. Make sure the
flat washer and (2) disc spring washers are in the proper order and orientation shown in fig. 11.
7. Tighten the retaining bolt to 30 – 37 ft –lbs (40-50 N-m).
8. To ensure safe operation of your mower, periodically check the blade bolt for correct torque

ENGINE CARE

A list of key engine maintenance items required for good performance by the mower is given below.
Service Item
Check Engine Oil
Change Engine Oil
Check Air Filter
Service Air Filter
Check Spark Plug
Service Spark Plug
Clean Around Muffler
1. Check engine oil level before each use and maintain oil level to the full mark on the dipstick. See section titled
"Checking and Adding Engine Oil" on page 13.
2. Service air filter every 25 hours under normal conditions. Clean every few hours under extremely dusty
conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced.
Never run the engine without an air filter installed. Running the engine without the filter can cause excessive
engine wear and damage.
3. Clean engine regularly with a cloth or brush. Keep the top of the engine free of debris to permit proper air
circulation. Remove all grass, dirt and combustible material from muffler area.
Questions? Call Toll Free at 1-800-737-2112
(Continued)
Each Use First 5 to 8
hours
√
√
√
√
Every Season or Every Season or
25 hours 50 hours
√
√
√
ENG - 17
Every Season or
100 hours
√
Copyright © 2016 MAT Engine Technologies, LLC
Service Date
Record