Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tester Description
Transmitter (Toner)
1. Power button
2. Transmitter-on LED
3. Transmitter output port
Receiver (Probe)
1.
1. Sensor tip
2. Detector LED
3. Sensitivity control
4. TEST button
5.
5. LED flashlight
Adapter Cables
1. Coax adapter with F connector
2. Data adapter with RJ45 connector
3. Phone adapter with RJ11 connector
4. Automotive fuse adapter
5. Alligator clip adapter
1.
2.
4.
2.
3.
1.
2.
3.
4.
3
Operation
WARNING:
Never trace energized wiring.
1. Open the storage case by pressing on the red latch.
Remove the appropriate adapter and connect it to the transmitter
output port. Connect the other end of the adapter to the cable
being traced.
3.
2. Momentarily press the power button on the transmitter (toner).
An LED will flash to indicate the transmitter is operating.
The transmitter will send a pulsating tone down the cable
being traced.
3. Press and hold the TEST button to activate the receiver (probe).
An LED flashlight will illuminate the work area.
4. The tone will become louder as the sensor tip moves closer to the
cable with the tone on it.
A red LED will illuminate as the signal gets stronger.
Adjusting the sensitivity control can help pinpoint
the cable when multiple cables are in close proximity.
5.
RED Latch
Open
Storage Case
Electric shock hazard. Do not use tester on live circuits.
Clips
RJ11
4
Publicidad
Tabla de contenido
