Craftsman 315.CG1150 Manual De Operacións página 11

STEP 7: CONNECTING THE LP GAS CYLINDER TO
THE REGULATOR
See Figure 15.
 Remove cap from LP gas cylinder.
 Hold the LP gas cylinder firmly and insert into the
regulator.
 Turn the cylinder clockwise taking care not to cross
thread the connection. Do not use tools.
NOTE: The regulator will seal in the cylinder valve
resulting in some resistance. An additional one-half
to three-quarters turn is required to complete the
connection. If you cannot complete the connection,
disconnect and repeat the above two steps. If you still
cannot complete the connection, DO NOT use this
regulator!
 Inspect valve connections. Look for any damage or
debris. Remove any debris. Never attempt to use
damaged or plugged equipment. See your local LP
Gas Dealer for repairs.
REGULATOR
ASSEMBLY
STEP 8: TESTING VALVES AND REGULATOR FOR
LEAKS
See Figure 16.
Connections on the valve were tested at the factory to
ensure no gas leaks were present. However, shipping and
handling could loosen connections. As a safety precau-
tion:
 Turn the control knob OFF ( O ).
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
 Make sure the LP cylinder is properly connected to the
LP gas cylinder valve.
If you hear a rushing sound, immediately remove the
LP gas cylinder. This sound means there is a major
leak at the connection. Correct the problem before
proceeding.
 Using a clean paint brush and a 50/50 mixture of mild
soap and water, brush soapy solution over all the
connections and fittings on the grill.
 "Growing" bubbles indicate a leak. Remove the LP gas
cylinder and recap the bottle.
NOTE: If leaks cannot be stopped, do not try to repair.
Call for replacement parts.
LP GAS
CYLINDER
Fig. 15
11 — English
).
REGULATOR
Fig. 16