Fisher&Paykel DE62T27C Instrucciones De Instalación página 33

Installation instructions 1-71 l_
Levelling the dryer
Check the dryer is level, and make necessary adjustments to the front leveling feet.
The rear l evelling feet a re self a diusting.
Final installation check list
Check that:
, No plastic or flexible metal foil is used in the exhaust ducting.
, Exhaust is rigid ducting or thick wall flexible metal ducting.
, All joints in the ducting are made with duct tape. It must not be connected with screws or other
= Ducting is clean and is connected to the dryer. ..
, Inserts are fitted to the two front feet. }
, Dryer _s _ eve_ across the f ront.
Additionaly for electric dryer models only, check:
o If installation is 208V, special element kit has been fitted (seepage 21 ).
° Dryer is plugged or directly wired into an approved fitting and is properly grounded.
° Dryer starts, heats, cools and shuts off.
° Customer has b een shown how touse t he dryer.
Additionally for gas dryer models only, check:
o Dryer isplugged intoan approved fitting a nd isproperly grounded.
o All fittings in the gas line are tested for leaks.
o Exhaust temperature increases, to confirm ignition has occurred.
- If ignition does not occur initially, it may be due to air in the gas lne or low voltage power supply.
- The g as r egulator valve m ay f a_l toopen _ f t he power supply falls b elow _ 0_ V olts.
- If the gas fails to flow or does not ignite, the dryer will automatically switch off.
° Customer has been s hown h ow touse t hedryer.
note: s, dryers have adrum reversal feature toreduce clothes tangle. Throughout the drying
cycle the motor will run for four minutes, then stop and run in the opposite direction for forty
seconds before reversing again.