Front Panel; Rear Panel - Peavey CS 800x4 Manual Del Usuario

Front Panel

Rear Panel

1
Switches & Controls
AC Power Circuit Breakers (1)
4 amplifier has two circuit breakers on the back panel. If circuit breaker shuts off during normal use,
The CS 800
®
x
push it back to the ON position once. If it will not stay ON, the amplifier needs servicing.
Input Attenuators (2)
Whenever possible, set the attenuators fully clockwise to maintain optimum system headroom. The four input
attenuator controls located at the front panel decrease gain (signal level) for the respective amplifier channels in all
modes. See the specifications at the end of this manual for standard voltage gain and input sensitivity information.
Mode Select Switch (3)
When operating in Bridged mode, both attenuators of a respective set of channels (i.e. channels 1 and 2 or 3 and 4)
must be in the same position so the speaker load will be equally shared between the channels. See the section on
Bridged Mono Operation for more information and precautions.
2
2
11
3