Service Instructions; Troubleshooting - Monti MBX Die Blaster Instrucciones De Servicio

® ®
MBX
Die Blaster
8.

Service instructions

1. All service work on the tool is only to be undertaken by qualified workshop personnel or the dealer where you pur-
chased the tool. Repair or servicing by unqualified personnel may result in injuries and/or damage to the tool.
2. Only use genuine spare parts on servicing this tool. If parts that are not approved are used or maintenance
instructions are not followed, the warranty will be rendered void and there may be a risk of injury.
9.

Troubleshooting

Fault Cause
Belt does turn or Compressor is not operating
turns slowly
Filter or compressed air hose blocked
Insufficient compressor pressure
Inadequate compressor performance
Compressed air hose too long
Diameter of compressed air hose too small
Compressed air motor insufficiently lubri-
cated
Valve or valve sealing ring faulty
Unusual noise Mechanical parts insufficiently lubricated
Belt or other machine parts faulty
Water entering the machine via the com-
pressed air supply
Heavy vibration of Adaptor system is not fastened correctly
the rotating belt
Foreign body jammed between spindle and
adaptor system
Adaptor system worn
Belt faulty
Adaptor system Screw not tightened or serrated lock washer
comes undone in not used
operation
Screw / serrated lock washer worn
Operating instructions
Solution
Switch on or check compressor
Clean compressed air line
Increase compressor pressure
Use more powerful compressor
Use compressed air hose of suitable length
Use compressed air hose of suitable size
Add a few drops of oil to the compressed air
connection
Servicing by qualified engineer
Servicing by qualified engineer
Fit new belt / servicing by qualified engineer
Servicing by qualified engineer
Re-fit adaptor system
Remove object and re-fit
Use new adaptor system
Fit new belt
Use serrated lock washer and tighten screw
Use new screw / serrated lock washer
GB
23