Special Safety Instructions - Monti POWER MBX AXIAL Manual De Instrucciones

®
MBX AXIAL
8. Do not perform any maintenance on the tool while the tool is connected to the
compressed air supply. Before replacing or inspecting accessories, such as the adaptor
system and MBX
9. Never touch the MBX
10. Regularly check the pneumatic connection lines and replace them if damaged. Keep
tool body dry, clean and free of oil and grease.
accidents.

4.3. Special safety instructions

1. Before each use, check the tool for damaged and defective parts or other conditions
that may affect tool operation. Never use the tool if it is damaged or set incorrectly.
All damaged safety devices, start levers or other defective parts must be repaired or
replaced by an authorized service technician. Never use the tool with a defective start
lever.
2. When working on small or moving parts, secure them with a vise or screw clamp.
3. Only use the tool with original MBX
®
MBX Belts. MBX
be used together with other accessories and other tools.
4. After replacing the MBX
5. The operating pressure for this tool is limited by the mounted pressure regulator
to protect the tool against damage. Never operate the pneumatic tool with an
operating pressure of more than 75 psi (5.2 bar) flow pressure at the compressed air
connection of the tool. The Belts can be changed quickly and easily as described below:
Notice!
Please use a hose rupture protection. This protects personnel and the working environment
from damage that can occur if a compressed air system or hose bursts!
6. Check compressed air at regular intervals. To ensure that the compressed air is clean
and lubricated, integrate a maintenance unit into the compressed air line if required.
7. Ensure that the Belts are not damaged when placing the tool on a work table.
8. When not in use, disconnect the tool from the compressed air supply and store it in a
suitable place to prevent accidental or unauthorized use in the absence of an
authorized operator.
9. When using the tool, always hold it by the tool body.
10. Always use MBX
®
11. The MBX
12. Never carry the tool by the compressed air hose. Protect the compressed air hose
from heat, sharp edges and being run over. (Use hose rupture protection if necessary).
13. If the tool suddenly feels different (vibration strength) or makes a different noise
(pitch), the tool should be switched off immediately and the accessories such as the
adaptor system or MBX
®
Belt.
®
Belt when the tool is in operation.
®
Belts are specially designed for use on MBX
®
Belt, check the adaptor system for correct installation.
®
Belt in the correct working direction.
Belt can produce sparks when working on hard surfaces.
®
Belt should be checked for damage.
A smeared tool body can lead to
®
accessories such as the adaptor system and
Operating instructions
®
devices and must not
EN
5