Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
DOOR REVERSAL
INSTRUCTIONS
NOTES:
• This appliance is intended for FREE-STANDING INSTALLATION ONLY,
and is NOT intended to be built-in.
• Before connecting this appliance to electrical power supply, leave it to
stand for approx. 24 hours, which will reduce the possibility of
malfunction in the cooling system due to transport handling.
• This appliance is approved for INDOOR USE ONLY and is NOT
intended for outdoor operation.
Install this appliance in an area where the ambient temperature is
between 55°F (13°C) and 90°F (32°C). If the temperature around the
appliance is too low or high, cooling ability may be affected.
Your refrigerator is built with a reversible door. You have the choice of
either opening it from the left or the right side. In order to reverse the
opening direction of your door, please follow these simple instructions:
Before you begin, unplug refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from doors.
To avoid injury to yourself and/or property, we recommend that
someone assists you during the door reversal process.
1) Unplug refrigerator or disconnect power.
2) Keep both doors closed until you are ready to remove them.
Note: Provide additional support for the doors while the hinges are being
moved. Do not depend on the door magnets to hold the doors in place.
3) Remove the parts for the top hinge as shown in Top Hinge graphic
Figure 8 on following page. Lift off freezer door.
4) Remove the parts for the center hinge as shown in the Center Hinge
graphic Figure 7 on following page. Lift off refrigerator door.
5) Remove the parts for the bottom hinge as shown in the Bottom Hinge
graphic Figure 6 on following page.
6) Remove the cover of upper hinge holes from left side and move it to
opposite side (see Figure 1 on following page).
7) Remove hole plugs from left side and move them to opposite side (see
Figure 2 on following page).
8) Remove door hinge hole plug from the top of freezer and refrigerator door
(see Figure 4 on following page).
9) Remove the door stop from refrigerator door and move to the other side
(see Figure 5 on following page).
IMPORTANT
IMPORTANT
3
Publicidad
