Further Safety Instructions - Grizzly KSG 220 Traducción Del Manual De Instrucciones Original

a specially prepared cord available
through the service organization.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured re-
sidual current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• Before use, carry out a visual in-
spection of the grinding disk. Do not
use grinding disks that are spalled,
cracked or otherwise damaged. Re-
place a worn grinding disk.
• Never operate the device without the
visual protection disk.
• Do not work with the device if you
are tired or after the consumption of
alcohol or tablets. Always take a break
from the work in good time.
• Do not use the device in an explosive
atmosphere or where sparks could
cause fire, explosion etc. Failure to
observe this will result in a risk of fire
or explosion.
• Keep your hands away from the
grinding disk and chain teeth when
the device is in use. Do not move the
chain by hand. This will cause a risk
of injury.
• Never place your fingers between the
grinding disk and rotary disk or be-
tween the grinding disk and protection
disk. This will cause a risk of crushing.
• The chain becomes hot during grind-
ing. Do not touch the machined loca-
tion, as there is a risk of being burnt.
• Use only grinding disks recommended
by the manufacturer. Do not use saw
blades.
• Switch off the device and disconnect
at the plug
- to release a jammed insertion tool,
- if the connecting cable is damaged
or tangled,
- in the case of unusual noises.
GB
123