U.S.Robotics R24.0232.00 Guia De Instalacion página 9

Connecting a Cable or DSL modem to the Broadband Router
4
To configure the Broadband Router for your specific ISP, launch a Web browser and type http://
192.168.123.254 to access the Configuration Utility. There is no default password for the Broadband
Router, so just click Login . Click Setup and follow the on-screen instructions. You will need any network
connection information you collected earlier.
Note: If you collected any network information earlier, you will need to enter this information into the
Setup WAN configurations screens.
5
After you have performed the configuration steps, the installation procedure is now complete. You
should now have secure and shared Internet access. To verify your connection, launch a Web browser
and go to www.usr.com . If the page loads, you are finished with the installation procedure. If the page
does not load, proceed to the Troubleshooting section of this Guide.
Note: It is recommended that you write down the settings for your Broadband Router for future
reference. You can view the settings in the Broadband Router Configuration Utility by logging in at http:/
/192.168.123.254.
The following graphic is a representation of your system topology after the installation of the Broadband
Router.
5