Troubleshooting - Whirlpool WDF331PAH Manual De Instrucciones Para El Usuario

Ocultar thumbs Ver también para WDF331PAH:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call,
refer to the warranty page in this manual and scan the code with your mobile device, or visit www.whirlpool.com/product_help.
In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Dishwasher is not operating properly
Dishwasher does not run or stops during a cycle
It is normal for certain cycles to repeatedly pause for several
seconds during the main wash.
Is the door closed tightly and latched?
Is the right cycle selected?
Is there power to the dishwasher? Has a household fuse
blown, or has a circuit breaker tripped? Replace the fuse
or reset the circuit breaker. If the problem continues, call an
electrician.
Has the motor stopped due to an overload? The motor
automatically resets itself within a few minutes. If it does not
restart, call for service.
Is the water shutoff valve (if installed) turned on?
The Clean light is flashing
Check the following:
Is the overfill protection float able to move up and down
freely? Press down to release.
Be sure the water supply is turned on to the dishwasher.
(This is very important following the new installation of
your dishwasher.)
Check for suds in the dishwasher. If foam or suds
are detected by the dishwasher sensing system, the
dishwasher may not operate properly or may not fill with
water.
Subs can come from:
1. Using the incorrect type of detergent, such as laundry
detergent, hand soap, or dish detergent for hand
washing dishes.
2. Forgetting to replace the rinse aid dispenser cap after
filling (or refilling) the rinse aid.
3. Using an excessive amount of dishwasher detergent.
Dishwasher will not fill
Is the overfill protection float able to move up
and down freely? Press down to release.

Troubleshooting

In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Center
200 – 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Dishwasher seems to run too long
Try the 1 Hour Wash cycle.
Is the water supplied to the dishwasher hot enough? The
dishwasher runs longer while heating water.
Is the dishwasher cycle time within the cycle times? See cycle
sections wash times. A delay automatically occurs in some
wash and rinse cycles until the water reaches the proper
temperature.
This dishwasher is equipped with an optical sensor wash that
detects water temperature, soil and detergent amount. Wash
cycles are adjusted based on the load sensing.
IMPORTANT: The very first wash cycle after installation
in your home will be adjusted to include an additional 2
rinses. This cycle must not be interrupted for proper sensor
adjustment. If this adjustment cycle is canceled or stopped
before the Clean light comes on at the end of the cycle, the
next wash cycle will repeat this sensor adjustment.
Water remains in the dishwasher
Is the cycle complete?
Was the disposer knockout plug removed during installation?
(See "Install the drain hose" section in the Installation
Instructions.)
Detergent remains in the covered section of the dispenser
Is the cycle complete?
Check for items such as cookie sheets, cutting boards, or
large containers that may be blocking the detergent dispenser
from opening properly.
Be sure the cycle has finished (green light is on). If it has not
finished, you will need to resume the cycle by pressing START/
RESUME and closing the door within 3 seconds.
Is the detergent lump-free? Replace detergent if necessary.
White residue on the front of the access panel
Was too much detergent used?
Is the brand of detergent making excess foam? Try a different
brand to reduce foaming and eliminate buildup.
Odor in the dishwasher
Are dishes washed only every 2 or 3 days?
Check and clean your filters regularly. See the table in
"Filtration System" section for "Recommended Time Interval
to Clean Your Filter."
Does the dishwasher have a new plastic smell? Run a vinegar
rinse as described in "Dishwasher Care."
To avoid odor, use affresh
tablet once a month or as needed for a fresher dishwasher as
described in "Dishwasher Care."
Condensation on the kitchen counter (built-in models)
Is the dishwasher aligned with the countertop? Moisture from
the vent in the dishwasher console can form on the counter.
Refer to the Installation Instructions for more information.
dishwasher and disposal cleaner
®
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Wdf320padw

Tabla de contenido