CleaningTheClipper - Panasonic ER‑GS60 Instrucciones De Funcionamiento

Cleaningtheclipper

• It is recommended to clean at every use.
• Always wash with water after wet trimming.
1. Remove the clipper from the AC adaptor.
▼
To remove light dirt
2. Remove the comb
attachment and turn the
clipper on.
3. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the clipper off.
• Rinse with water and
shake up and down
several times to remove
the water.
▼
▼
To remove heavy dirt
2. Remove the comb
attachment and blade.
3. Clean the clipper, the blade
and the comb attachments
with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
▼
4. Wipe off the water with a towel and
let it dry naturally.
• It will dry faster with the blade
removed.
5. Apply the oil to the blade after
drying. (See page 14.)
6. Attach the comb attachment and
blade to the clipper.
Cleaningwiththebrush
1. Remove the clipper from the AC
adaptor.
• Make sure that the clipper is
turned off.
2. Remove the comb attachment.
3. Hold the main body, place your
thumb against the blades and then
push them away from the main
body.
4. Brush off any hair trimmings from
the main body and from around the
blade.
13