Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Connections
a)
Route the alarm system harness around the rear frame to the original harness and secure it with tie raps
(picture 4)
b)
Route the harness under the rear frame (picture 4-A).
c)
Identify the 4-pin connector (picture 5-A) of the alarm pre-arrangement, remove the counterpart and insert
the corresponding harness connector.
d)
Identify the 1-pin connector (picture 5-B) (+12V) and insert the harness counterpart.
e)
Place the fuse housing as indicated (picture 5-C).
f)
Secure the harness and the fuse housing with three tie raps as shown in picture 5.
g)
Place the LED on the left bike rear fairing (picture 6).
h)
Apply the rear fairing on top of the rear frame close to its original position, identify and disconnect the 2-pin
connectors of the turn signals and interpose the harness counterparts for the right and left turn signals.
i)
Route the LED cable to the harness counter part.
j)
Remount the rear fairing in accordance to the service manual.
Caution: assure that no cables are clamped between the cowling and frame or will get damaged.
k)
Reconnect the negative battery pole and remount the seats and side covers.
3.
System check and test
a)
To arm the system push once BUTTON 1 of the remote control.
Arming is confirmed by:
•
Turn indicators flash two times (right-left-right-left)
•
2 acoustic signals (bleep)
•
LED turns on (quick flash)
The system is operating after 40 sec. «Standby Time»: the motorbike cannot start
b)
Move the motorbike to test that movement sensor is operating
during 30 sec.
c)
At the end of the alarm phase the LED is steady ON.
d)
To disarm the system push BUTTON 1 of the remote control
Disarming is confirmed by:
•
Turn indicators flash once (right-left)
•
1 acoustic signal
LED gives 1 flash every 5 sec. to confirm an alarm due to a position variation
impulse (ON-OFF) on the ignition key.
e)
To activate the PANIC alarm push once BUTTON 2 of the remote control
are flashing during 30 sec. (to stop this test push BUTTON 1 or BUTTON 2).
f)
Re-assemble the parts previously removed.
g)
End of installation.
4.
What to be done before delivering the motorbike to its owner
a)
Deliver to the owner the two remotes control together with the metal plate where the releasing emergency
"PIN CODE" is printed.
b)
Explain to the owner the releasing emergency procedure.
SUZUKI GENUINE ACCESSORIES
Led flashes slowly
siren sounds and turn indicators are flashing
to reset the alarm memory give an
the siren sounds and turn indicators
3
Publicidad
