Installation Requirements; Tools And Parts; Location Requirements - KitchenAid BRIVA KIDS42 Instrucciones De Instalación

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here. Additional tools may be required to cut contertop and
install drain lines.
Tools needed:
Utility knife
5/8" open-end wrench
7/16" deep well socket
small tubing cutter
tape measure
flat bladed screwdriver
plumber's putty
10" adjustable wrench that opens to 1-1/8" (2.9 cm)
Teflon ® tape or pipe joint compound
1 cartridge silicone caulk and caulk gun
sink strainer locknut wrench
Parts needed:
Copper tubing with compression fitting for water fill line (3/8"
is recommended). Length needed is determined by specific

installation requirements.

Copper tubing with compression fittings for faucet connection.
Length and diameter needed are determined by specific
faucet installation requirements.
faucet
2, 1-1/2" drain P traps
3-1/2" sink strainer
90° elbow with 3/8" N.P.T. external threads on one end.
(The other end must fit your water supply line.)
In addition, if direct wiring:
1/4" hex nut driver
2, twist-on connectors of proper size to connect house wiring
to 16-gauge dishwasher wiring.
CSA-certified, U.L.- or C.-U.L. listed conduit connector to fit
7/8" (2.2 cm) hole
Parts supplied:
Undercounter clamp brackets – adjustable for countertops
3/4" (1.9 cm) to 1-1/2" (3.8 cm) thick
cutting board
INSTALLATION REQUIREMENTS

Location Requirements

Protect dishwasher and water lines leading to dishwasher against
freezing. Damage from freezing is not covered by the warranty.
If dishwasher will be left unused for a period of time or in a
location where it may be subject to freezing, have it winterized by
authorized service personnel.
The dishwasher is shipped ready for installation of a one-hole
faucet. If a two-, three-, or four-hole faucet is to be installed, the
holes must be added by a qualified plumber, according to the
faucet manufacturer's specifications.
If the hot water accessory tank, Part No. 4396282 will be used,
the tank should be installed first. It may be difficult to install the
drain line to the T&P valve on the hot water accessory tank, if it is
not installed first.
3