Assembly & Set-Up; Contents Of Carton - Troy-Bilt Flex Serie Manual Del Operador

Assembly & Set-Up
Read entire Operator's Manual before
you attempt to assemble or operate
your new water pump.
If you have any problems with the assembly of
your water pump, please call (800) 828-5500. If
calling for assistance, please have the model and
serial number available.

Contents of Carton:

• FLEX™ Water Pump Attachment
• Suction Hose with Strainer
• Discharge Hose
• Operator's Manual
• Owner's Registration Card
• Fast Start Guide
Unpack Water Pump
1. Open carton completely by cutting each
corner from top to bottom.
2. Remove the FLEX™ Water Pump
Attachment, its accessories and literature,
and any cardboard inserts included with the
water pump.
WARNING! This attachment weighs
61 lb. and requires two people to lift it.
3. Ensure you have all included items prior to
assembly.
Set-Up
To setup the Water Pump attachment:
1. Wrap the suction hose with strainer around
the suction hose storage and secure it
using the suction hose tie down strap.
See Figure 3-1.
Suction Hose
Tie Down Strap
Suction Hose
Storage
Suction Hose
with Strainer
Figure 3-1
6
2. Roll the discharge hose flat and store
it using the discharge hose storage.
See Figure 3-2.
Figure 3-2
Your FLEX™ Water Pump Attachment is now
setup and ready to be used in a wide variety of
applications. Proceed to the next section in this
manual to learn about the controls and operation
of the FLEX™ Water Pump.
Discharge Hose
Discharge Hose
Storage
3