Troy-Bilt Flex Serie Manual Del Operador página 8

FLEX™ Water Pump Operation
Preparing the Water Pump
1. Rotate the pump head to the desired position
by removing the four screws (a). Once in the
desired position, then snug down the four
screws (a). Do not overtighten. See Figure 4-4.
(a)
Figure 4-4
2. Connect the suction hose to the pump's
suction port. See Figure 4-5.
Figure 4-5
Note: Make sure hose is properly installed
and tightened in order to achieve proper
suction. Also, you may need to weigh down
the strainer end of the suction hose in order
to achieve proper suction.
8 S 4 — c
ection ontrolS
3. Connect the discharge hose to the pump
discharge port. See Figure 4-6.
Note: Make sure discharge hose is properly
installed, tightened and once in use that
it is not kinked in order to achieve proper
discharge.
4. Before starting engine, remove the primer
filler plug and completely fill the pump
chamber with water. See Figure 4-7.
CAUTION! We do not recommend
running the FLEX™ Power Base, and
water pump attachment without first
ensuring the pump is primed with
water.
& o
peration
Figure 4-6
Figure 4-7