Types Of Work - Hilti TE 500-AVR Manual De Instrucciones Original

5.2 Types of work

WARNING
Risk of electric shock! Severe injury and burns can result if any
attempt is made to operate the tool without an earth/ground conductor
and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used,
always make sure that an earth/ground conductor and ground fault
circuit interrupter are present in the power supply and that these are
correctly connected.
▶ Do not use the product unless these safety measures are in place
and fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply
cord or extension cord if damaged while working. Disconnect the supply
cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it
replaced by a qualified specialist if found to be damaged.
Full approval must be obtained from the site engineer or architect prior to
beginning the work.
5.2.1 Chiseling 5
▶ Set the function selector switch to the
5.2.2 Switching sustained operation on and off
Note
When chiseling, the on/off switch can be locked in the "on" position.
1. Push the lockbutton for continuous operation forward.
2. Press the on/off switch as far as it will go.
◁ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
◁ The product switches off.
10 English
Printed: 09.08.2017 | Doc-Nr: PUB / 5367058 / 000 / 01
position.
6