Safety; Operation - Liemke KEILER–13 PRO CERAMIC Manual De Instrucciones

04. SAFETY

The rated charging voltage of this product is 5V.
> Please charge in time when power is low, so as to avoid service
life loss caused by battery over-discharge.
The thermal imager is not recommended to be used in high
temperature environment for a long time, if the temperature is too
high, the imager will enter the high-temperature protection state,
and automatically shut down.
The recommended temperature for use −10°C to +50°C.
> Make sure that the USB port cover on the bottom of the thermal
imager is tightly closed when using in damp environments, e.g.
rainy days.
> Under any circumstances (whether on or off), do not expose
the lens of the thermal imager directly to high-intensity radiation
sources (such as the sun, laser, etc.), to avoid irreversible dama-
ge to the device.
> When the device is not used for a long time, it should be char-
ged at least every 2 months during storage and stored in a dry
and ventilated environment.
> The device should not be charged in an environment above
40°C.
Disposal of waste electrical equipment and batteries
Do not dispose of waste electrical equipment and batteries
in the household waste. Please hand them in to your local
recycling centre. Batteries should be fully discharged when
disposed of.
CE marking

05. OPERATION

ATTENTION!
The lens of the device must not be pointed
at any sources of intense energy, such as
laser-emitting devices or the sun. This may
damage the electronic components in the
device. Damage caused by failure to comply
with the operating guidelines is not covered
under warranty.
KEILER-13/-18 PRO CERAMIC · Operating Manual 11 / 2020
The devices are in conformity with the EU
directives:
EMC Directive 2014/35/EU
RoHS Directive 2011/65/EU
E
N
12
–
13