Safety Instructions; Operation - Liemke MERLIN–35 Manual De Instrucciones

05. SAFETY INSTRUCTIONS

The thermal imager is not recommended to be used in high
temperature environment for a long time. If the temperature is too
high, the imager will enter the high-temperature protection state,
and automatically shut down.
The recommended temperature for use is −10°C to +50°C.
> Make sure that the USB interface cover on the side of the ther-
mal imager is tightly closed when used in humid environments,
e.g. on rainy days.
> Do not expose the lens of the thermal imager directly to high-in-
tensity radiation sources (such as the sun, lasers, etc.) under any
circumstances (whether switched on or off) to avoid irreversible
damage to the unit.
Disposal of waste electrical equipment and batteries
Do not dispose of waste electrical equipment and batteries
in the household waste. Please hand them in to your local
recycling centre. Batteries should be fully discharged when
disposed of.
CE marking

06. OPERATION

CAUTION!
Do not point the lens of the unit at intense energy
sources, including laser units and the sun. Otherwise,
there is a risk of damaging electronic components
of the unit. Damage resulting from non-compliance
with the operating instructions is not covered by the
warranty.
Before use
A technical inspection of the device is recommended before use.
> Check the external appearance of the device: There should be
no cracks in the casing.
> Check the condition of the lens and eyepiece: There should be
no cracks, greasy spots, dirt or other deposits.
> Check the condition of the battery: It should be charged if
necessary.
> Check all electrical contacts: There must be no salts or oxidised
spots.
The devices are in conformity with the EU
directives:
EMC Directive 2014/35/EU
RoHS Directive 2011/65/EU