Gas Dryer Installation Requirements; Earthing Instructions - Maytag MDE18PD Instrucciones De Instalación

Electrical Requirements
IMPORTANT: Observe all governing codes and ordinances.
You will need an earthed electrical outlet located within 610 mm
(2 feet) of either side of the dryer.
This dryer is supplied/fitted with an electrical supply cord and plug.
It should be connected to electrical supply socket at the voltage
shown on the rating plate. The minimum supply fuse capacity
should be 10A. The dryer must be positioned so that the plug is
clearly visible and accessible. This plug also provides the function
of an emergency stop control for the user. If the fitted plug is not
used, the electrical connection must be carried out by a competent
electrician in accordance with local or national codes.
If the supply cord is damaged, it must be replaced with a specially
terminated cord by an authorized service agent or a similarly
competent person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordance with the European EMC Directive
(2004/108/EC), the maximum electricity supply system impedance
to which the gas dryer should be connected is declared to be
0.054 Ohm + j0.034 Ohm.
NOTE: Electrical safety standards: The manufacturer has chosen
compliance with IEC/EN.60335 standards as the most appropriate
for this product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.

GAS DRYER INSTALLATION REQUIREMENTS

Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits your
2. Secure the plug end in place on the cord by aligning the 2 cover

EARTHING INSTRUCTIONS

SAVE THESE INSTRUCTIONS
electrical outlet, and plug it into the adapter on the supply cord.
halves over the cord adapter and clipping them together.
11