Descargar Imprimir esta página

Prior To Commissioning; Beginning Work With The Machine - diversey TASKI aquamat 10.1 Instrucciones Originales De Uso

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42

Prior to commissioning

Prepare carpet
Notice:
Vacuum the carpet before working with the
carpet cleaning machine.
For visible stains, treat the carpet with a
TASKI stain remover. Please contact your
Diversey service partner for help.
• Spray a 10% solution across the entire surface with the
help of the spray device and spray lance; leave to work for
10-15 minutes.
Fill tank
• Release the locking head for the re-
covery tank.
• Remove the recovery tank.
• Fill the fresh water tank with water,
max. 9 l at max. 40 °C.
• Observe the fill line.
• Replace the recovery tank. Ensure
that the tank latches correctly.
Application technique
Machine
Wet cleaning
Dry cleaning
Cleaning parquet and laminate
floors
36
aquamat 10.1
Yes
No
No

Beginning work with the machine

• Press both switches.
• Begin in the furthest corner.
• Press the spray valve action lever.
The water is sprayed onto the carpet
and immediately sucked up again.
• Pull the extension cord towards you.
The slower you pull it, the more thor-
ough the cleaning.
• Release the action lever for the spray
valve and suction approx. 10 cm fur-
ther.
• Lift off the squeegee.
• Start a new strip. For this, the squee-
gee should overlap a part of the pre-
vious strip.
Continue working in this manner until
the entire surface is cleaned.
Notice:
To avoid water splashes:
Before disconnecting the spray hose, al-
ways:
- Switch the pump switch to OFF.
- Operate the manual valve again in order
to reduce the pressure in the spray hose.
Transport over stairs
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Unplug the mains plug.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
Attention:
The attached accessories must be re-
moved before lifting!
Attention:
Both the fresh water and the recovery tank
must be emptied completely before lifting
the machine.

Publicidad

loading