Remote Control - Chamberlain Merik LiftMaster 7511LMK Manual De Instrucciones

Remote Control

Your remote control has been programmed at the factory to operate with your garage door opener.
Older LiftMaster remote controls are NOT compatible, see page 36 for compatible accessories.
Programming can be done through the door control or the learn button the garage door opener. To
program additional accessories refer to the instructions provided with the accessory or visit
www.merik.com.mx. If your vehicle is equipped with a Homelink
depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional
information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps above for programming additional remote controls or keyless entry
devices. If programming is unsuccessful, program the remote using the learn button.
1
The command LED
will flash once.
3
®
, you may require an external adapter
2
The command LED will
flash once again.
OR
? ? ? ?
PIN
PROGRAM USING THE GARAGE DOOR OPENER
1. Locate the Learn button on the garage door opener.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Press and hold the button the remote control that you wish to use. Release the button when
the garage door opener lights blink or two clicks are heard. If programming to other products,
press the button a second time to activate products.
1-2
LEARN LED
30
3
LEARN
Button