Basics
Making calls
(*TONE)
(REDIAL)
Additional tasks
To
Adjust the handset volume
Switch to tone dialing
temporarily
Notes
• When you increase the sound volume, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If your conversation is muted and "CHANNEL SEARCHING" appears on
the display, move closer to the base unit; otherwise, the call will be
disconnected after one minute.
20
US
Basics
VOL switch
Do this
Set the VOL switch to H (high), M (middle) or L
(low).
Press (*TONE) after you're connected.
The line will remain in tone dialing until
disconnected.
1
Pick up the handset from the
base unit.
2
Press (TALK) and wait until
"TALK" appears on the display.
The display also shows the
operation duration in hours,
minutes and seconds.
You will then hear a dial tone.
The IN USE lamp on the base
unit lights up.
If "CHANNEL SEARCHING"
appears on the display, move
closer to the base unit.
3
Dial the phone number.
4
When you're done talking, press
(OFF) or replace the handset on
the base unit.
The display and the IN USE
lamp on the base unit go off.