Adding A T1 Tonematch; Audio Engine (Optional) - Bose L1 Model II Guía De Usuario

English English Dansk Deutsch Español Dansk

Adding a T1 ToneMatch

Figure 6
Mounting the T1
Mounting bar
2
Carriage
Locking knob
1
Français Deutsch Italiano Nederlands Español
®

audio engine (optional)

audio engine provides additional input/output capabilities to your 
The T1 ToneMatch ®
system, plus digital signal processing to customize the way you sound. The audio engine
comes with hardware for mounting it on the left or right side of the L1
bottom arrays.
Note: The audio engine mounts on the bottom section of the loudspeaker and requires removal
of the top section before starting this procedure.
1. Slide the carriage into the channel on the rear of the L1 bottom and turn the knob 
clockwise to lock it in place (Figure 6).
2. Insert the mounting bar into the slot in the carriage and push it downward.
3. Place the T1 on the mounting bar as shown.
4. Plug one end of the ToneMatch cable (supplied with the audio engine) into the 
ToneMatch output port (
5. Using the hook and loop strap, secure the cable to the carriage.
6. Plug the other end of the cable into the ToneMatch port on the power stand.
T1 ToneMatch
audio engine
3
L1 model II 
bottom array
Français Svenska Italiano
) on the T1.
ToneMatch cable 
(supplied with T1)
Nederlands Svenska
S
YSTEM
® model II top and
T1 ToneMatch
audio engine
4
Hook and loop strap
5
L1 model II 
bottom array
6
Power stand
S
ETUP
13