Battery Replacement; Maintenance - KS KSL00943 Manual De Instalación Y Mantenimiento

BATTERy REPLACEMENT

when the battery weakens, the LED indicator light will blink at a constant rate. The
battery must be replaced within two weeks.
1. unscrew the holding 2 .Carefully open the battery
screw
box
4. Replace the used batteries
5. Close the box
with a new 6 x 1.5V
batteries (Lithium battery is
recommended).
IMPORTANT: Spent batteries should not be disposed of with normal
household waste. Contact your local authority for information on
waste disposal and recycling.
10
3 .Remove the old
batteries

MAINTENANCE

FILTER CLEANINg INSTRuCTIONS
The system is provided with one stainless steel filter preventing foreign particles
to enter the lines. It is recommended to clean the filters every six (6) months.
If the water flow has decreased, this may be because the filter is clogged. The
filters can be cleaned as follows:
1. Shut-off the water shut off valve.
2. Disassemble the faucet and remove the filter located between the solenoid
housing and the flexible pipe.
3. wash the filter under running water.
4. Reassemble the parts.
5. Make sure that there is no water leakage.
SOLENOID VALVE SERVICINg
The solenoid valve diaphragm requires periodical cleaning every six (6) month.
Remove the diaphragm from the solenoid valve and examine it for dirt. in case it
is dirty or clogged, wash it under running water and reassemble it.
Do not attempt to dismantle the solenoid valve if you are unfamiliar with
electronic solenoid valves.
CARE AND CLEANINg OF CHROME AND SPECIAL FINISHES
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives,
or the like. use of any prohibited cleaning or maintenance products or sub-
stances could damage the surface of the shower. For surface cleaning of faucets
use ONLY soap and water, then wipe dry with clean cloth or towel. when clean-
ing bathroom tile, the faucet should be protected from any splattering of harsh
cleansers
11