GE RAK348R1 Instrucciones De Instalación página 16

INSTALLATION INSTRUCTIONS
LINK THE RECEIVER (cont.)
A. Press the SW4-INSTALL button inside the thermostat. Press
the HEAT/COOL button on the front of the thermostat to
select your choice. Press the UP button to set the receiver
number (0-7) and press the HEAT/COOL button to set the
receiver.
Internal Buttons
SW12-RESET SW4-INSTALL SW9-LINK
SW12-RESET SW4-INSTALL SW9-LINK
Display
Install
Node
Good
B. Press the SW9-LINK button inside the thermostat.
Within 5 seconds, press the RESET/LINK button (PB3) on the
receiver. The "Good" message will appear if linked. The "Bad"
message will appear if not linked.
C. Press the SW4-INSTALL button to close the installation
session.
PB1–NETWORK
Used to uninstall the thermostat
from receiver(s) it has been
linked to.
SW12–RESET
Master Reset – Returns thermostat
to all factory defaults.
SW4–INSTALL
Starts an installation session.
SW9–LINK
Used to link the thermostat to
control receiver(s).
NOTE: The display always blinks
HEAT
COOL
the item that is active and can
be changed.
Please Wait
Printed in China