Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
5
Install Suppor t Bracket
1. Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown in Fig.15A. Mark brackets at top level
of sill, and remove.
2. Assemble sill angle bracket to support
brackets at the marked position(Fig.15B).
Hand tighten, but allow for any changes later.
NOTE: Check that air conditioner is tilted back about
1
5
1 / to 1 / (tilted about 3 t o 4 downward t o th e o utside).
4
8
After proper installation, condensate should not drain
from the overflow drain h ole d uring n ormal u se, c orrect
the slope otherwise (Fig.14).
Window Sash
FIG.14
Measure from
the cabinet edge.
Window Sill
Mark
Fig.15A
Bottom
Rail Seal
3 4 (or1
/2
)Long
Hex-head Screw
Fig.13
O
O
1
About1 / to1 /
4
5
Side Louvers
Sill Angle Bracket
Locknut
Sill Angle
Bracket
Flat Head
Bolt
3. Install support brackets(with sill angle
brackets attached) to correct hole in
bottom of cabinet as shown in Fig.16.
4. Tighten all 6 bolts securely.
5
8
6
Extend Window Filler Panels
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top(Fig.17).
3. Close window behind top angle.
7
1 2 Long Screws
Left
And Locknuts
2 Each Required For
Each Support Bracket
Fig.15B
Fig.16
Fig.17
Right
1 2 Long Screws
and Locknuts
7/16"Locking Screw
and Washer
Publicidad
