U.S.Robotics R24.0376.00 Guia De Instalacion página 8

Troubleshooting
My computer does not recognise the 22 Mbps Wireless Access Point after I
changed the settings.
Possible Solution:
Ensure that the Access Point Configuration Utility is installed for your 22 Mbps Wireless Access
Point and that the Configuration Utility is installed and functioning for your 22 Mbps Wireless PC
Cards or PCI Adapters.
Possible Solution:
Ensure that you are contacting the correct 22 Mbps Wireless Access Point by verifying the MAC
address.
Possible Solution:
Ensure that the correct password and encryption option are being used. If you changed the
settings in the configuration of the 22 Mbps Wireless Access Point, you must also change the
settings of every 22 Mbps Wireless PC Card or PCI Adapter attached to this network. The settings
of the 22 Mbps Wireless PC Cards or PCI Adapters must match the new settings of the 22 Mbps
Wireless Access Point. If you are still experiencing difficulties, reset all of your 22 Mbps Wireless
Access Points and wireless network adapters to the default settings and try again.
I am unable to communicate with a 22 Mbps Wireless Access Point.
Possible Solution:
Be sure that each Wireless PC Card or PCI Adapter that you want to connect to the wireless
network is set to Infrastructure mode within the Configuration Utility. If your 22 Mbps Wireless PC
Cards or PCI Adapters are not set to Infrastructure mode, they will not be able to communicate
with the 22 Mbps Wireless Access Point.
My 22 Mbps Wireless PC Card or PCI Adapter does not see my Wireless
Access Point in the list when I scan for it.
Possible Solution:
You may be on a computer that is physically too far away from the Wireless Access Point. Try
moving closer to the Wireless Access Point and repeating the scan procedure. Check any physical
connections between the Wireless Access Point and your modem, router, hub, LAN, or switch.
I accidentally clicked Cancel during the installation procedure for the 22
Mbps Wireless PC Card or PCI Adapter.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive. Repeat the
installation procedure of the software before you install any hardware.
The installation procedure did not begin when I inserted the Installation
CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from beginning.
Close any open applications and reinsert the Installation CD-ROM.
4